What it does
The tool above is a visual noise meter for classrooms. It shows the sound level of the room as animation, with no numbers to explain to young students.
- Three themes. Balls that bounce higher as the room gets louder, bubbles that rise and grow with the noise, and emoji faces.
- Number of balls. From 10 to 60. Fewer balls are calmer and easier to read from the back of the room.
- Sensitivity. Controls how strongly the balls react. Raise it for a small quiet group, lower it for a full room.
- "Too loud" limit. When the room goes over your limit, the balls turn red and shake, and the counter goes up by one.
- Optional "shh" sound. Plays when the limit is passed. It is off unless you switch it on.
- Fullscreen. One click fills the projector or smartboard.
- Shareable settings link. Bookmark your setup or send it to a colleague.
- Nothing recorded. Sound is measured on your device and never leaves it.
If you would rather show a bar, traffic light or the level in decibels, use the main classroom noise meter.
Set it up in two minutes
- Open this page on the computer connected to your projector, press Start and allow the microphone.
- Put the microphone in a sensible place. Near the middle of the room is best. Keep it away from fans, open windows and the projector's own speaker, and use the same spot every day.
- Run a test minute. Ask the class to work at the voice level you want. Adjust the sensitivity until the balls move gently at that level, low on the screen.
- Set the limit a little above that. If the balls turn red for every chair scrape or cough, raise the limit slightly.
- Go fullscreen and bookmark the settings link so tomorrow starts the same way.
Why a visual signal helps
We are not going to claim that bouncing balls improve learning. The case for a visual noise meter is simpler than that:
- It is immediate. Students see the effect of their own noise as it happens, without waiting for a reminder.
- It is shared. The display shows the room, not one child. The whole class owns the result.
- It replaces repeated verbal reminders. You can point at the screen and keep teaching.
- It makes "too loud" concrete. Young children often cannot judge their own volume. A ball that stays low is a target they can see.
- It reaches students who miss spoken cues, including students who are hard of hearing or still learning English.
How well it works depends on the routine around it. A display nobody refers to becomes wallpaper within a week.
Tips from the classroom
- Stop the "make them bounce" game early. The first time, every class shouts to see the balls fly. Allow it for ten seconds, then set the real goal: keep the balls on the floor.
- Use the counter for a class goal. For example, fewer than five red moments during a 15-minute work block.
- Match the theme to the task. Bubbles are calmer and suit independent work. Balls or emoji suit group work and younger classes.
- Save the "shh" sound for when you need it. A sound that plays all the time stops working, and noise-sensitive students may find it unpleasant.
- Do not use it all day. Bring it out for the activities where noise matters, so it stays interesting.
- Hide it if it distracts. During tests, some students watch the screen instead of their paper. Switch to the plain bar on the classroom meter or turn the display off.
How accurate is it?
For this job you only need a consistent signal: quieter or louder than your limit. Any working microphone gives you that. The limit is shown in decibels, but an uncalibrated laptop microphone can read several decibels high or low, so set it by watching your own room and not from a chart. Our accuracy page explains why. For an actual measurement with averages and a graph, use the decibel meter. This is a teaching aid and is not meant for judging hearing risk. For that, see safe decibel levels.
Frequently asked questions
How does the bouncy balls noise meter work?
It listens through your device's microphone and turns the loudness of the room into movement. The louder the room, the higher the balls bounce. When the room goes quiet they settle at the bottom.
Is it free?
Yes. It runs in the browser with no account, no download and no time limit.
Does it record my class?
No. The microphone signal is turned into a loudness number on your device and then discarded. No audio is recorded, stored or uploaded.
The balls don't move. What should I check?
Make sure you pressed Start and allowed microphone access, that the right microphone is selected in the browser, and that the sensitivity is not at its lowest. If your smartboard has no microphone, run it on a laptop and mirror the screen.
Is there a bubble version?
Yes. Choose the bubbles theme and bubbles rise from the bottom and grow as the noise increases. There is also an emoji faces theme.
Can I save my settings?
Yes. The shareable settings link stores your theme, number of balls, sensitivity and limit in the address. Bookmark it and the meter opens ready to use.
Updated