Published figures
| Source | Chainsaw level |
|---|---|
| CCOHS (Canadian Centre for Occupational Health and Safety) | 106–115 dBA |
| CDC and Yale EHS | 110 dB |
| ASHA | 112 dBA |
| Purdue University | 120 dB |
All of these describe a gasoline saw as heard by the person holding it. The engine runs at high speed about half a meter from the operator's head, and the chain adds its own noise as it cuts.
How fast the safe time runs out
NIOSH recommends an average of no more than 85 dBA over 8 hours, with the allowed time cut in half for every 3 dB above that. For a chainsaw the result is striking:
| Level at the ear | Recommended daily maximum without protection |
|---|---|
| 106 dBA | under 4 minutes |
| 109 dBA | under 2 minutes |
| 112 dBA | about 1 minute |
| 115 dBA | about 30 seconds |
Cutting up a single fallen limb takes longer than that, so a chainsaw exceeds the daily limit almost as soon as work starts. Hearing protection belongs in the standard kit alongside chaps, gloves and eye protection.
Choosing protection
- Earmuffs are quick to put on and take off between cuts and are the usual choice. Check that safety glasses are not breaking the cushion seal.
- Foam earplugs work well only when inserted deeply.
- Both together are worth it for long sessions. The reduction needed to bring 110 dBA down to 85 dBA is 25 dB, and real-world attenuation from a single protector is often less than the rating on the package.
What changes the level
- Engine size and throttle. Full throttle in a cut is the loudest condition; idle is far lower.
- Power source. Battery and corded electric saws have no engine exhaust, so they are generally quieter, though the chain and motor still make substantial noise. Check the rating for the model, and do not assume protection is unnecessary.
- Chain condition. A dull chain means longer cuts and more time at full throttle.
Bystanders
Sound falls about 6 dB for each doubling of distance outdoors, so a saw that is 110 dBA at the operator's ear is still roughly 84 to 90 dBA for a helper standing 5 to 10 meters away. Anyone working nearby needs ear protection as well.
Measuring a chainsaw
A phone held by the operator will overload, since most phone microphones stop reading accurately a little above 100 dB. Measure from a distance instead: stand 10 meters away while someone else makes a cut, read the decibel meter, and add roughly 26 dB to estimate the level at half a meter. Then use the noise exposure calculator to see the dose for your cutting time. Reference pages: 110 dB and 115 dB.
Sources
- CCOHS: Noise - Basic Information
- Purdue University: Noise Sources and Their Effects
- ASHA: Noise and Hearing Loss Prevention
- CDC: noise levels and hearing loss (archived)
- Yale Environmental Health & Safety: Decibel Level Comparison Chart
- NIOSH: Noise and Occupational Hearing Loss
Frequently asked questions
How many decibels is a chainsaw?
About 106 to 120 dB at the operator: CCOHS gives 106–115 dBA, the CDC and Yale 110 dB, ASHA 112 dBA and Purdue 120 dB.
How long can you run a chainsaw without hearing protection?
By NIOSH guidance, under 2 minutes a day at about 110 dBA. In practice you should wear protection every time.
Are electric chainsaws quiet enough to skip ear protection?
Do not assume so. They are generally quieter than gas saws, but levels vary by model, so check the rating or measure it.
Updated