This page is about hearing safety. The figures come from a federal occupational health study of training staff and are presented to explain the noise hazard.
The measured levels
In 2014 the National Institute for Occupational Safety and Health (NIOSH) published a health hazard evaluation of impulsive noise at a law enforcement training facility. Investigators recorded the following peak sound pressure levels inside a training building:
| Device and location | Peak level |
|---|---|
| Full-load, in a doorway | 171.8 dB |
| Full-load, middle of a room | 168.4 dB |
| Full-load, in a walkway | 157.8 dB |
| Reduced-load, across all locations | 151.1–168.8 dB |
The highest readings occurred in doorways. The report attributes this to the shock wave reflecting off the nearby wall and door frame. The recorded waveform showed one very large initial impulse followed by reverberant impulses that died away over about half a second.
How that compares
In the same evaluation a 12-gauge shotgun peaked at about 172 dB in a doorway and a rifle at about 163 dB. A flashbang is therefore in the same class as close-range gunfire, and all of these are far above the 140 dB peak ceiling that NIOSH and OSHA apply to impulse noise. Decibels are logarithmic: 170 dB is 30 dB above that ceiling, which is a thousand times the sound energy.
What it means for hearing
- One exposure can cause harm. Above 140 dB peak, a single unprotected impulse can produce permanent hearing loss or tinnitus. There is no safe listening time.
- Enclosed spaces make it worse. The 14 dB gap between the walkway and doorway readings came from the surroundings alone.
- Protection should be doubled. For impulse noise at these levels, hearing specialists recommend an earplug worn under an earmuff. The NIOSH report recommended dual protection for instructors during these exercises.
- Peak is not the whole picture. NIOSH notes that the hazard of an impulse also depends on its duration and energy, so two events with the same peak are not necessarily equal.
Anyone exposed without protection who notices ringing, muffled hearing or ear pain afterward should see an audiologist or physician promptly.
Why a phone cannot measure this
Consumer microphones, including those in phones and laptops, overload far below 140 dB and cannot follow an impulse that rises in a fraction of a millisecond. NIOSH used specialized pressure microphones and high-speed data systems for this study. A browser meter is the right tool for steady everyday sound, not blasts. For background, see 150 dB, safe decibel levels and the OSHA noise limits page, which covers the 140 dB peak rule.
Sources
- NIOSH Health Hazard Evaluation Report 2013-0124-3208: impulsive noise at firing ranges during tactical training (2014)
- NIOSH: How Can We Measure Impulse Noise Properly?
- Meinke et al., "Prevention of Noise-Induced Hearing Loss from Recreational Firearms," Seminars in Hearing (2017)
Frequently asked questions
How many decibels is a flashbang?
NIOSH measured full-load devices at 158 to 172 dB peak and reduced-load devices at about 151 to 169 dB peak during indoor training.
Can a flashbang cause permanent hearing damage?
Yes. The measured peaks are well above the 140 dB limit, where a single unprotected exposure can cause permanent hearing loss or tinnitus.
Is a flashbang louder than a gunshot?
They are comparable. In the same NIOSH study a 12-gauge shotgun peaked at about 172 dB and a rifle at about 163 dB in a doorway.
Updated