How Loud Is a Train Horn?

Federal regulations require a train horn to produce at least 96 dBA and no more than 110 dBA, measured 100 feet in front of the locomotive.

Measure your room against 110 dB a train horn

Press “Measure now” and allow the microphone to compare your surroundings with this level.

0
Threshold of hearing
30
Whisper
60
Conversation
85
Hearing risk (8 h)
120
Threshold of pain
140
Impulse limit
194
Max undistorted sound
A train horn: 96–110 dB

Measured 100 ft (30 m) ahead of the locomotive.

NIOSH recommended daily limit at 110 dBA: 1 min (85 dBA for 8 h, halved every 3 dB). Calculate a full day.

The number is set by law

Unlike most entries on a decibel chart, the loudness of a train horn in the United States is written into federal regulation. Under 49 CFR 229.129, every lead locomotive must carry a horn that produces a minimum of 96 dB(A) and a maximum of 110 dB(A) at 100 feet forward of the locomotive in its direction of travel. The rule sets a ceiling as well as a floor, so a horn can fail inspection for being too loud.

How loud is it closer or farther away?

In open air, sound from a compact source drops about 6 dB each time the distance doubles. Applying that rule of thumb to the legal range gives a rough picture. These are estimates, not measurements, and real levels shift with buildings, terrain and wind.

Distance ahead of the locomotiveEstimated level
25 ft (about 8 m)108–122 dBA
50 ft (15 m)102–116 dBA
100 ft (30 m), the legal test point96–110 dBA
400 ft (120 m)84–98 dBA
1,600 ft (490 m)72–86 dBA

For comparison, Purdue University lists a freight train passing at 15 meters, without the horn, at about 80 dB.

When and how horns are sounded

The Federal Railroad Administration's Train Horn Rule requires engineers to begin sounding the horn at least 15 seconds, and no more than 20 seconds, before reaching a public highway-rail grade crossing. The standard pattern is two long blasts, one short and one long, repeated or prolonged until the locomotive occupies the crossing. Communities can apply for a quiet zone, where routine horn use is dropped in exchange for extra crossing safety measures; horns may still be used in an emergency.

Hearing risk

At 110 dBA, NIOSH's exposure guideline allows well under two minutes a day. A horn sequence at a crossing lasts 15 to 20 seconds, so a single pass heard from the roadside is brief. The concern is repetition, since a home or workplace near a busy crossing may hear many sequences a day, including at night.

See how these levels sit on the scale at 110 dB and 95 dB.

Logging train noise at home

If you live near a line, a record of how often and how loud is more persuasive than a single reading. Run the noise monitor at an open window overnight to capture each pass, then use the noise exposure calculator to total it. Readings above roughly 100 dB may be clipped by a phone microphone, so treat them as minimums.

Sources

Frequently asked questions

How many decibels is a train horn?

Between 96 and 110 dBA at 100 feet in front of the locomotive, the range required by 49 CFR 229.129.

How long does a train have to sound its horn?

Under the FRA Train Horn Rule, for at least 15 seconds and no more than 20 seconds before a public grade crossing, in a long-long-short-long pattern.

Can a train horn damage your hearing?

A single pass from the roadside is short, but at up to 110 dBA the daily limit is reached in under two minutes, so repeated close exposure is a real risk.

Updated

Tools and guides