What a 20 Hz tone is used for
20 Hz is the figure usually quoted as the lower limit of human hearing. Below it, sound is called infrasound. The limit is not a hard wall: sensitivity falls steadily as frequency drops, so a 20 Hz tone has to be very strong before you notice it, and it is often felt as pressure or vibration more than heard as a note.
The main practical use is checking how low a subwoofer or a pair of headphones really goes:
- Subwoofer extension. Many subwoofers begin to fade somewhere between 25 and 40 Hz. If 20 Hz produces only a faint flutter while 30 Hz and 40 Hz are strong, you have found the edge of its range.
- Rattles. A long 20 Hz tone shakes loose panels, shelves and window frames that music does not hold still long enough to reveal.
- Port and driver noise. A chuffing or ticking sound at 20 Hz is the port or the driver complaining, not the tone itself.
Why you may hear nothing
One cycle of a 20 Hz wave is about 17 meters long in air. A small speaker cannot move enough air to produce it, so silence on a phone or laptop is normal. If you hear a clear buzz or hum on small speakers, you are hearing distortion: harmonics at 40, 60 and 80 Hz that the speaker creates because it cannot follow the signal. Use the sine waveform so that the test signal itself contains no harmonics.
To test the whole bass range, run a slow sweep from 20 to 200 Hz on the main tone generator.
Sources
- HyperPhysics (Georgia State University): Sensitivity of the human ear (audible range 20 Hz to 20,000 Hz)
- Sonarworks: Room modes (axial mode formula)
- Elliott Sound Products: Why do tweeters blow when amplifiers distort? (long-term tweeter power handling)
Frequently asked questions
Can humans hear 20 Hz?
Many people can if the tone is strong enough, but it is at the edge of hearing and is often felt more than heard. Sensitivity drops steeply at low frequencies, so 20 Hz has to be far more intense than a midrange tone to be noticed.
Why can't I hear 20 Hz on my phone or laptop?
Small speakers cannot move enough air to reproduce a 20 Hz wave. You need a capable subwoofer or good headphones, and even then the tone will be faint.
Is a 20 Hz tone safe for my subwoofer?
At low volume, yes. At high volume a steady 20 Hz tone drives the cone to its largest excursion and can damage it, especially on ported subwoofers tuned higher than 20 Hz. Keep the level low and the test short.
Updated