50 Hz Tone Generator

Play a steady 50 Hz sine tone. It is the frequency of mains electricity in most of the world, so it is the reference for tracking down hum, and it is a standard bass test tone.

440Hz

A4

Start at low volume. High frequencies at high volume can damage hearing and tweeters.

Wave
Output
Frequency sweep
Frequency
50 Hz
Nearest note
G1 (+35 cents)
Period
20 ms
Wavelength in air
6.86 m (22.5 ft)

50 Hz is the mains frequency in most countries

Mains electricity alternates 50 times per second in Europe, most of Asia and Africa, Australia and parts of South America. North America and some other regions use 60 Hz. Japan uses both: 50 Hz in the east, including Tokyo, and 60 Hz in the west.

When mains power leaks into an audio signal, you hear hum. Compare the tone on this page with the noise from your equipment:

To see exactly which frequencies your hum contains, hold a phone running the spectrum analyzer near the speaker and look for peaks at 50, 100 and 150 Hz.

50 Hz as a bass test tone

50 Hz is low bass that many mid-sized speakers still reach. Full-size bookshelf and floor-standing speakers usually play it. Phone and laptop speakers do not. It is also a common tone for checking a subwoofer's level against the main speakers. A room dimension of about 3.4 m (11 ft) has its first resonance at 50 Hz, so in a small room the level can change sharply as you move.

Need a different frequency? Use the main tone generator.

Sources

Frequently asked questions

Which countries use 50 Hz electricity?

Most of the world: Europe, most of Asia and Africa, Australia and parts of South America. North America uses 60 Hz. Japan uses 50 Hz in the east and 60 Hz in the west.

Why does my speaker hum at 50 Hz?

Mains power is getting into the audio signal. Common causes are a ground loop between two connected devices, an unshielded cable close to a power transformer, or a single-coil guitar pickup. Hum from ground loops is often strongest at 100 Hz.

Can I hear 50 Hz on a laptop?

Usually not. Laptop and phone speakers are too small to reproduce it. Use headphones or larger speakers.

Updated

Tools and guides